Epson SC-F9200 Series Service Manual page 257

SC-F9200 Series
3.4.10.5 Drying Fan
(p252)
1. Remove the Drying Fan Unit.
2. Remove the Drying Fan Cover. (p254)
3. Disconnect the cables of the Drying Fan from the relay connector.
4. Release the cables from the clamp.
Route the cables as shown below.
5. Remove the two screws, and remove the Drying Fan.
A) Silver M3x30 screw: 2 pcs
Make sure to install the Drying Fan in the correct orientation
checking the cable position.
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure
Relay Connector
A
Clamp
Drying Fan Unit
Cable
Figure 3-215. Removing the Drying Fan
SE Group Confidential (Related Staff Only)
Revision B
Drying Fan
A
257