Epson SC-F9200 Series Service Manual page 247

SC-F9200 Series
3.4.9.4 Sub-F Board (Reel)
1. Remove the Roll Paper Holder of the Right Reel Unit.
2. Disengage the hook, and remove the cover.
3. Disconnect the cable from the connector (CN600) on the Sub-F Board.
See Figure
4. Remove the four screws. (
A) Silver M3x8 S-tite screw with built-in washer: 4 pcs
5. Remove the two screws that secure the Right Reel Side Cover. (
3-202.)
B) Silver M3x8 S-tite screw with built-in washer: 2 pcs
6. Slightly lift the Right Reel Cover, and remove the Right Reel Side Cover.
Tighten the screw that secures the Right Reel Side Cover together
with the grounding wire.
DISASSEMBLY & ASSEMBLY
(p246)
3-203.)
See Figure
Disassembly and Assembly Procedure
Cable
CN600
Sub-F Board
B
Secure with the
Right Reel Unit
grounding wire.
Figure 3-202. Removing the Cover
Right Reel Cover
A
A
Figure 3-203. Removing the Right Reel Side Cover
SE Group Confidential (Related Staff Only)
Revision B
Right Reel
Side Cover
B
Cover
Hook
A
A
247