Epson SC-F9200 Series Service Manual page 204

SC-F9200 Series
3.4.5.22 PW Sensor
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p260)
perform the specified operations including required adjustment.
When replacing the PW Sensor, make sure to replace the IM
C H E C K
P O I N T Sensor, too.
(p98)
1. Unlock the CR Unit.
2. Remove the Left Rear Cover. (p110)
(p111)
3. Remove the Left Upper Cover.
(p139)
4. Remove the CR Cover.
5. Move the CR Unit to the left end.
6. Remove the screw that secures the Sensor Cover.
A) Silver M3x8 P-tite screw with built-in washer: 1 pcs
Insert the two dowels of the Sensor Cover into the two positioning
holes on the CR Unit.
7. Disengage the two hooks, and remove the Sensor Cover.
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
Disassembly and Assembly Procedure
- Left Side of the CR Unit -
CR Unit
Positioning holes
and dowels
Figure 3-148. Removing the Sensor Cover
SE Group Confidential (Related Staff Only)
Revision B
Hooks
A
Sensor Cover
204