Epson SC-F9200 Series Service Manual page 193

SC-F9200 Series

Secure the screws that secure the Ink Supply Tube with
tightening torque about 0.29 ± 0.05 Nm.

Attach the Joint as shown in the figure below.
Ink Holder 1 (Home)
18. Remove the four screws that secure the Ink Holder 2.
H)Silver M4x10 S-tite screw with built-in washer: 4 pcs
At the next step, be sure to remove the IC Holder slowly and
C A U T I O N
carefully not to damage the Ink Tubes and cables with the sharp
metal edges of frames.
19. Remove the IC Holder 2 pulling out the Ink Tubes and cables.
When installing the Ink Holder 2, pay attention to the followings.

Do not fold the ink tubes.

Be careful not to let the ink tubes and the cable get caught
between the Ink Holder and the frame of main body.

Before attaching the Joint Rubbers, let them get wet with
cleaning liquid (CL14).

Confirm there are no foreign objects attached on the Joint

Rubbers.

If the Joint Rubbers are deformed, restore it to its original
shape manually.
DISASSEMBLY & ASSEMBLY
Ink Holder 2 (Full)
Red mark
Red mark
Disassembly and Assembly Procedure
Before installing the new Ink Holder 2, be careful of the following
points.

Remove the packaging bag from the Ink Holder 2.

Loosen the two each screws of the joints, and remove the tubes.

Since ink still remains in the removed tube, make sure to
dispose of it according to local regulations.
Packaging bag
Tube
Joints and
screws

Remove the four tubes from the ink supply needles.
Tubes
SE Group Confidential (Related Staff Only)
Revision B
Ink Holder 2
Tubes
193