Recommended Tools - Epson SC-B7000 Series Service Manual

SC-F7000 Serie/SC-B7000 Series

3.1.4 Recommended Tools

To protect this product from damage, use the tools indicated in the following table.
For the tools required to perform the adjustment, refer to "Tools/Consumables for
Adjustments" in Chapter 4.
Table 3-1. Tools
Name Description
4 cm or longer shaft length (The
Phillips screwdriver, No. 1 one with a magnet is
recommended)
25 cm or longer shaft length (The
one with a magnet is
recommended)
Phillips screwdriver, No. 2
Stubby driver with 4 cm or shorter
shaft length (The one with a
magnet is recommended)
Short type with a 20-mm or shorter
Ratchet screwdriver
head
Tweezers Nothing in particular
C-ring pliers To remove C-rings (φ25).
To secure the cable/harness, or for
Acetate tape the protection against the sharp
edge
To prevent staining the printer
Waste cloth
with ink during operation
DISASSEMBLY & ASSEMBLY
Target Part
Print Head
Some encoders/sensors
Parts in general
APG Unit
Platen Heater
Driven Roller Gear
Parts in general
Roll Paper Holder
Parts in general (Use this tape
when it is removed or when
replacing the part)
Ink Tube
Ink Holder
Flushing Box
Damper Kit
Print Head
Pump Cap Unit
Overview
Revision A
46
Confidential