Ink End Error; Wrong Ink Mixture Error - Epson SC-F9200 Series Service Manual

SC-F9200 Series

2.6.1 Ink End Error

Ink End Error ("Refill Ink Tank.") occurs even sufficient ink remains in the ink tank
(Remaining ink level is 70 mm or more from the bottom of the Ink Tank).
Table 2-8. Ink End Error
Cause
Foreign material came in from the spout of the
ink tank, and it caused filter clogging inside
the ink tank and blocked ink flow, then Ink
End Error occurred.
Installation of the ink tank is not appropriate,
so ILS cannot be detected correctly.

2.6.2 Wrong ink mixture error

If wrong color ink is filled in an ink tank during filling ink, carry out the procedure
below.
REQUIRED TOOL
 Cleaning cartridges (CL14) (2 to 4 pcs)
 New ink tanks (2 to 4 pcs)
 New chip unit (for 2 to 4 colors. See below for which colors should be prepared.)
C H E C K Due to the structure of this printer, you cannot replace only one
P O I N T
tank. Therefore, replacement of the tanks should be made
according to the combinations below.
•
BK and M
•
Y and C
TROUBLE SHOOTING
Remedy
Replace the ink tank with a new one. Discard
the old tank and the ink inside the tank.
Check the detection condition of ILS from
Sensor Check in the Serviceman Mode.
OFF: ILS is detected.
ON: ILS is not detected correctly.
If ON is displayed, re-install the corresponding
ink tank.
Other Troubles
REMEDY
1. Turn on the printer.
2. Discard the waste ink.
3. Turn off the printer.
4. Start the printer in the Serviceman Mode.
Turn on the printer while pressing [Menu] + [Back] + [OK].
5. Remove the ink tank in which wrong ink was filled and the other ink tank of the
corresponding color combination given below.
C H E C K Due to the structure of this printer, you cannot replace only one
P O I N T
tank. Therefore, replacement of the tanks should be made
according to the combinations below.
•
BK and M
•
Y and C
6. Lower the lock levers.
7. Start the service program and select
ADJUSTMENT (Sequence).
8. Select Ink Eject.
Select the corresponding color rows, and press the
ink eject. (Page 332)
9. Select Activation of Cleaning Cartridge.
Select the corresponding color rows, and press the
cleaning cartridge. (See P.331)
10. Turn off the printer.
11. Install the cleaning cartridges. (Page 207)
12. Lower the lock levers.
13. Turn on the printer.
14. Discard the waste ink.
SE Group Confidential (Related Staff Only)
Revision C
(Page 207)
Resolution of mixing ink error from
[Run] button to carry out the
[Run] button to validate the
72