Epson SC-F9200 Series Service Manual page 239

SC-F9200 Series
3.4.8.4 Sub-F Board (Roll)
1. Remove the Roll Paper Holder of the Right Roll Unit.
2. Disengage the hook, and remove the cover.
3. Disconnect the cable from the connector (CN600) on the Sub-F Board.
4. Remove the four screws that secure the Right Roll Cover. (
A) Silver M3x8 S-tite screw with built-in washer: 4 pcs
5. Remove the two screws, and remove the Right Roll Side Cover. (
3-192.
)
B) Silver M3x8 S-tite screw with built-in washer: 2 pcs
6. Slightly lift the Right Roll Cover, and remove the Right Roll Side Cover
Insert the two ribs of the Right Roll Cover into the two positioning
holes on the frame.
DISASSEMBLY & ASSEMBLY
(p238)
See Figure 3-193.
)
See Figure
Right Roll Cover
Ribs
Disassembly and Assembly Procedure
Right Roll Side Cover
B
Cover
Hook
Figure 3-192. Removing the Cover
Right Roll Cover
A
A
Figure 3-193. Removing the Right Roll Side Cover
SE Group Confidential (Related Staff Only)
Revision B
Cable
CN600
Sub-F Board
B
Right Roll Unit
A
A
239