Epson SC-F9200 Series Service Manual page 196

SC-F9200 Series
3.4.5.19 Ink Tube
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p260)
perform the specified operations including required adjustment.
REQUIRED TOOL
 Ink Cartridge for service (8 pcs)
 USB cable
 Service program
 Communication driver
PREPARATION BEFORE REPLACEMENT
1. Start the printer in the Serviceman Mode.
Turn on the printer while pressing [Menu] + [Back] + [OK].
2. Start the service program and select
ADJUSTMENT (Sequence).
3. Select Ink Tube Counter.
Press the [Run] button to reset the counter.
4. Turn off the printer.
5. Turn on the printer.
6. Discard the waste ink.
7. Select Switch between Ink cartridges and Ink
Select All channels and Ink Cartridge for
validate the ink cartridges for service.
8. Turn off the printer.
9. Remove all the ink tanks. (p207)
10. Lower all the lock levers.
11. Start the printer in the Serviceman Mode.
Turn on the printer while pressing [Menu] + [Back] + [OK].
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
When replace ink holder from
(p293)
tanks.
service, and press the [Run] button to
(p329)
Disassembly and Assembly Procedure
12. Select Ink Eject.
Select All channels, and press the
13. Turn off the printer.
REPLACEMENT
1. Remove the Media Loading Lever.
(p101)
2. Remove the Panel Unit.
3. Remove the Right Upper Cover.
(p110)
4. Remove the Left Rear Cover.
5. Remove the Left Upper Cover. (p111)
(p116)
6. Remove the Upper Cover.
(p139)
7. Remove the CR Cover.
8. Remove the screws that secure the Ink Path Holder Assy. (See
Duct CR" (P. 140)
)
9. Remove the Ink Path Joint from the Ink Tubes Path. (See
CR" (P. 140)
)
10. Remove the screw one each on the two Ink Tube Holders, and remove the holders.
A) Silver M3x8 P-tite screw: 2 pcs
SE Group Confidential (Related Staff Only)
Revision B
[Run] button to run the ink eject. (p332)
(p210)
(p103)
Step 5 in
"3.4.5.2 Duct
Step 6 in
"3.4.5.2
196