Long Paper Jam - Fuji Xerox Versant 3100 Press Printer Unit Manual

3.2.4

Long Paper Jam

If you open the cover of printer unit while printing a long paper, the paper is remained in the paper feed-
ing unit and you cannot remove the paper.
In this case, remove the paper with the following steps.
1.
Close the cover of printer unit.
2.
Wait until the paper is passed to the Transfer Module.
When the paper is transferred, a message in the Error Message area is changed.
3.
Pull the Transfer Module out, and then remove the paper remained in the area, "2a" or
"2c".
While pulling the Transfer Module out, stop when the jammed paper is visible, and then continue to pull
it out with the paper holding down by a hand.
Refer For detailed information on Step 3, refer to "3.2.1 Paper Jams in the Transfer Module" (p.41).
When Optional Units are Installed
If the jammed paper is lying across more than one unit, open the levers of units on both sides that are
indicated in the Error Message area before you remove the jammed paper.
Levers you may open if the jammed paper is lying across multiple areas include:
Printer Unit...3a

Interface Decurler...1c

Inserter...1a, 1d

High Capacity Stacker...entry: 1b; exit: 3b

Crease and Two-sided Trimmer...entry: 1a; exit: 1d

Folder Unit...2a

Finisher...1a

For example, if a paper jam occurs in the location shown in the figure above, you must open "3a" for
Printer Unit, "1c" for Interface Decurler, "1a" and "1d" for Inserter, and "1b" for High Capacity Stacker
before you can remove the jammed paper.
Chapter 3 Problem Solving
47