Setting / Deleting Horizontal Tabs - Tally T5023+ Programming Manual

Horizontal print control

Setting / deleting horizontal tabs

ESC D
27 68
1B 44
Function:
– Setting tabs
Using ESC D ... NUL up to 32 column positions in the current character width
can be set as horizontal tabs.
The tab values are specified as n1, n2, etc. between 1 and 137 inclusive in
ascending order. Tab positions, which exceed the right margin, are ignored.
The sign NUL marks the end of the command.
– Using ESC D NUL the set tabs are deleted (NUL sign directly after ESC D)
– A horizontal tab jump takes place via the command HT (for ASCII
i
decimal 9 and hex 09).
– The absolute tab position is dependent on the set character size
(10, 12 or 15 cpi) and the print mode (condensed, elongated, nor-
mal). With proportional spacing the tab positions are set according
to the character size 10 cpi. Subsequent alterations to the charac-
ter size do not affect the absolute tab positions.
– With condensed print the spacing of the tabs amounts to 60 % of
the character width, with elongated print double the normal charac-
ter spacing.
– After switching on the printer or after initializing (ESC @) the tabs
are set at a spacing of eight 10-cpi characters.
84
(n1) (n2)
n1 n2
n1 n2
T5023/5023+ - Programming Guide
... NUL ASCII character
... 0 Decimal
... 00 Hexadecimal
Standard commands
.