Copying The Character Set Into The Ram - Tally T5023+ Programming Manual

Switching on italic print

Copying the character set into the RAM

ESC :
27 58
1B 3A
Function:
It is advisable to use this command when only a few characters of a resident cha-
racter set are to be modified.
Before the definition of a new character (using ESC &), any resident character
set can be copied into the RAM of the printer using ESC :
The desired resident character set, for example the draft standard character set
or an LQ type font, is activated for this using the appropriate control command,
for example, using ESC x (1) (LQ character set) or ESC S (n) (superscript/ sub-
script). Subsequently, the current character set is copied into the RAM using
ESC : NUL (n) NUL. n is the number of the LQ type font specified in the standard
command ESC k (n), for example (see "Standard commands" chapter, section
"Selecting the LQ type font (ESC k (n))").
154
NUL (n) NUL
NUL n NUL
NUL n NUL
T5023/5023+ - Programming Guide
Character set commands
ASCII character
Decimal
Hexadecimal