Tally T5023+ Programming Manual page 302

The following intending formats are currently implemented:
GB 2312-80 VR China
GB 5007 VR China
GB 5199 VR China
BIG5 Traditional
Chinese
(Hongkong and
Taiwan)
When a 2-byte character generator is available, this character generator is
automatically enabled after power-on.
After a default font number has been specified, the relevant character is set.
If a default font number is not specified in the character generator, the character
set selected from the operating panel menu will be set.
Control sequences under 20h and/or ESC sequences will be executed where
possible.
When character codes from the 1-byte range of characters are transferred, the
LQ font currently set and the corresponding character set will be printed.
292
For character assignment see Appendix,
section „Chinese Characters in the Pass-
book / Document Printer".
For character assignment see Appendix,
section „Chinese Characters in the Pass-
book / Document Printer".
For character assignment see Appendix,
section „Chinese Characters in the Pass-
book / Document Printer".
For character assignment see Appendix,
section „Chinese Characters in the Pass-
book / Document Printer".
T5023/5023+ - Programming Guide
Control of Asian Character Sets