Tally T5023+ Programming Manual page 213

Additional commands (Printer) Basic commands for document processing
n = 0 : manual error handling
After an error the operator must clear the error via the operating panel
of the printer and put the printer into ONLINE status (also
operating manual)
n = 1 : automatic error handling
After an error the following actions are executed by the printing unit:
– Locking the printer interface for further data;
– Response 'Global printer status' in the coding CSI n ! z with n=2
(ERROR);
– Response 'Special printer message' in the coding CSI n; m " z
with n=2 (NO PAPER);
– Paper ejection, deletion of all print buffers, setting of default para-
meters;
– Response 'Global printer status' in the coding CSI n ! z with n=0
(ONLINE);
– Release of the interface for the transfer of new data.
The operator no longer needs to clear the error status on the printing
unit. However, after a short pause (ejection of the document) the
printing unit is in the ONLINE status again for the system driver and
can thus be addressed.
The default value n=0 (manual error handling) is valid after switching
i
on the printer. Other control commands, initializations or error
statuses do not change this parameter.
T5023/5023+ - Programming Guide
see the
203