Program Steps (Annotated) - Tally T5023+ Programming Manual

Application examples

Program steps (annotated)

1. Setting MSR parameters
Command:
Parameters:
Remarks:
2. Specifying the horizontal leading edge (logical)
Command:
Parameter:
Remarks:
3. Reading the magnetic stripe (MSR data)
Command:
Remarks:
CSI n1; n2; n3; n4; n5 ! r
n1 = 0
(no write repetitions = default value)
n2 = 0
(no read repetitions = default value)
n3 = 0 (write/read format = DIN)
n4 = 99
99/ 180 inch = 14 mm)
n5 = 1 (bottom leading edge)
This parameter combination corresponds to
the default setting of the document printer
for MSR processing. Therefore, this program
step could be omitted, if previously another
parameter setting was not selected.
CSI n % t
n = 1 (form guidance on right)
This program step is only relevant if 'left
leading edge' mode is set as default.
CSI " r
If the passbook is not inserted and drawn in,
this command initiates a document request
(READY
T5023/5023+ - Programming Guide
Passbook processing with MSR
(vertical distance from leading edge =
LED on the operating panel flashes).
267