Switching On The 'Single Density' Graphics Mode - Tally T5023+ Programming Manual

Syntax of the graphics commands

Switching on the 'single density' graphics mode

ESC K
27 75
1B 4B
Function:
The 8-dot graphics mode 'single density' is switched on with ESC K (n) (m).
The parameters n and m determine the number of dot columns to be printed:
Number of dot columns = m * 256 + n
One data byte must be specified per dot column.
– The section "Mode of operation of the graphics commands" con-
i
tains further notes on the command ESC K (n) (m).
– Using ESC ?, any graphics mode of the document printer can be
assigned to the command ESC K.
168
(n) (m) Data...
n m Data...
n m Data...
T5023/5023+ - Programming Guide
Graphics commands
ASCII character
Decimal
Hexadecimal