Switching On The 'Double Density And Double Rate' Graphics Mode - Tally T5023+ Programming Manual

Syntax of the graphics commands
Switching on the 'double density and double rate' graphics
mode
ESC Y
27
89
1B
59
Function:
The 8- dot graphics mode "double density and double rate" is switched on with
ESC Y (n) (m).
The parameters n and m determine the number of dot columns to be printed:
Number of dot columns = m * 256 + n
One data byte must be specified per dot column.
– The section "Mode of operation of the graphics commands" con-
i
tains further notes on the command ESC Y (n) (m).
– Using ESC ?, any graphics mode of the document printer can be
assigned to the command ESC Y.
170
(n) (m) Data...
n m Data...
n m Data...
T5023/5023+ - Programming Guide
Graphics commands
ASCII character
Decimal
Hexadecimal