Print quality and character size
Selecting the LQ type font
ESC
27
1B
Using ESC k (n) the following type fonts in LQ print quality can be selected:
n = 0
LQ type font Roman
n = 1
LQ type font Sans Serif
The selection of the type font can take place in draft or in LQ mode. The selected
type font is only actually printed in LQ print quality mode (switch with ESC x (1)).
The selection of further fonts not corresponding to the allocation of the IBM- 2 cha-
racter set is via a separate command (see "Selection of type fonts/ character sets" in
the "Additional commands" chapter)..
The characters of the different type fonts are available in the character si-
i
zes 10 cpi, 12 cpi, 15 cpi and proportional
Example:
BEGIN
PRINTLF(char(27),"x",char(1)
PRINTLF(char(27),"k",char(0),
"type font Roman")
PRINTLF(char(27),"k",char(1),
"type font Sans Serif")
END
Result:
96
k
(n)
107
n
6B
n
T5023/5023+ - Programming Guide
ASCII character
Decimal
Hexadecimal
.
<-- LQ-mode on
Standard commands