Tally T5023+ Programming Manual page 357

Appendix
Variable initialisation parameters 4722 emulation:
IBM4722 Switch - Electronic Board
IBM4722 Switch 1 Audible Alarm
IBM4722 Switch 2 Zero Slash
IBM4722 Switch 3 Automatic Line Feed Emulation menu LF (LF = LF)
IBM4722 Switch 4 Reserved
IBM4722 Switch 5 Character Set
IBM4722 Switch 6 Automatic CR
IBM4722 Switch 7 Reserved
IBM4722 Switch interface card
SW 1..3 Baud rate
SW 7 Reserved
It is normally not necessary to set the operating panel parameters in the
i
4722 emulation.
Fixed initialisation parameters 4722 emulation:
Parameters
Top of form position
Char. density
Char. width
Country
Left edge
Ref. edge
T5023/5023+ - Programming Guide
T5023/5023+ Setting
Not supported
Not supported
Character set 2
Emulation menu CR (CR = CR)
Character set 2
Interface menu
9600,4800,2400,1200 (9600)
Interface menu Protocol (DTR)
Emulation menu Multi Part (OFF)
Emulation menu Typeface DQ,
Roman, Sans Serif (DQ-Sans Serif)
T5023/5023+ parameter
in the 4722 emulation
Line 2 (6 LPI)
10 CPI
Normal
USA
Column 1 (10 CPI)
Left
IBM Emulations
347