Selecting The Character Set - Tally T5023+ Programming Manual

Character set commands

Selecting the character set

ESC
27
1B
Function:
Using ESC t (n), one of the following character sets of the complete upper cha-
racter table is selected:
– Italic character set (n= 0)
The upper character table contains the italic characters of the current cha-
racter set (draft, LQ or defined by the user). The upper control code table
contains control codes (identical to those of the lower control code table).
– Graphics character set (n= 1)
The complete upper character table contains graphics characters and inter-
national special characters.
– Character set defined by the user (n= 2)
The upper character table contains the characters defined by the user. The-
se characters can be used simultaneously with the standard characters
(ROM) without switching character set. For this, 128 must be added to each
code assigned with ESC & when defining the characters.
– The introductory section "Selection of the character set" in this
i
chapter contains the character tables of the individual character
sets.
– If ESC t (2) is used without previously defining characters, the up-
per and lower character tables are identical.
t (n)
116 n
74 n
T5023/5023+ - Programming Guide
Switching on italic print
ASCII character
Decimal
Hexadecimal
149