Print Modes - Tally T5023+ Programming Manual

Standard commands

Print modes

The use of different print modes (e. g., bold print, elongated print, underlining) ena-
bles a document to be structured for optical effect. This section describes the com-
mands for the selection of the print modes.
Command
SI
ESC SI
DC2
SO
ESC SO
DC4
ESC W (n)
ESC w (n)
ESC E
ESC F
ESC G
ESC H
ESC - (n)
ESC S (n)
ESC T
ESC ! (n)
– By selecting condensed or elongated print the width of the charac-
i
ters is changed (condensed = 60% of the normal character width,
elongated = 200% of the normal character width).
– Not all print modes and character sizes can be combined. Invalid
combinations are pointed out in the description of the individual
commands.
– Using ESC ! (n) it is possible to switch on or off all print modes (with
the exception of superscript and subscript), the character sizes 10
cpi and 12 cpi, proportional spacing and italic print on or off with a
single command.
Function
Switch on condensed print
Switch on condensed print
Switch off condensed print
Switch on elongated print for one line
Switch on elongated print for one line
Switch off elongated print for one line
Switch elongated print on/ off
Activate / deactivate double character height
Switch on bold print
Switch off bold print
Switch on double impact print
Switch off double impact print
Switch underlining on/off
Switch on superscript/subscript
Switch off superscript/subscript
Select combined print mode
T5023/5023+ - Programming Guide
.
Print modes
101