Paper Feed Of The Document - Tally T5023+ Programming Manual

Basic commands for document processing Additional commands (Printer)

Paper feed of the document

CSI
ESC [
27
91
1B
5B
Parameter:
n = 0 : Ejection of a document
n = 1 : Insertion of a document to the base line of the logical first linewhich
can be set via the document printer menu (TOF- POS)
Function:
This command initiates a mechanical action. The ejection procedure also refers
to documents which were only form fed and on which no insertion or print proce-
dure was carried out.
If this command is used to eject documents (n = 0), it must be considered that
after ejection the current logical position is outside the form. Therefore a new first
print position must be set here before transferring new print characters, for ex-
ample, using the command FF (form feed) or via paper feed of the document
(positioning on the base line of the logical first line, see definition of default po-
sitioning for
insertion) or using the command "Absolute vertical positioning".
This control command triggers printing of characters still in the print buf-
i
fer. It immediately causes a mechanical vertical movement which can
be secured via a control cycle. Because a mechanical optimization of
movement is avoided by means of the insertion command, this control
command should only be used when the insertion procedure must be
secured separately via control cycles.
190
n $ p
n $ p
n 36 112
n 24 70
T5023/5023+ - Programming Guide
Name
ASCII character
Decimal
Hexadecimal