Tally T5023+ Programming Manual page 91

Standard commands
– The absolute margin position is dependent on the set character
i
size (10, 12 or 15 cpi) and the print mode (condensed, elongated,
normal). With proportional spacing, the right margin is determined
according to the character size 10 cpi. Subsequent alterations to
the character size have no influence on the set margin.
– The distance between the left and right margins must be at least
two 2/10"(two characters with 10 cpi).
– ESC Q (n) should be entered at the beginning of a print line, as
ESC Q (n) deletes all the previously entered characters and tabs in
the same print line.
Example:
A demonstration of what effect a right margin has on the carriage return and line feed.
(For the influence of the current character size on the right margin compare with con-
trol command for "Setting the left margin").
BEGIN
SET N = 30
REPEAT
SET N = N + 4
PRINT(char(27),"Q",char(N))
PRINT("Line length equal to the distance") margin
PRINTLF(" between left and right margins")
UNTIL N = 42
END
Result:
T5023/5023+ - Programming Guide
Horizontal print control
<-- Setting the right
81