Specification Of The Horizontal Leading Edge - Tally T5023+ Programming Manual

Basic commands for document processing Additional commands (Printer)

Specification of the horizontal leading edge

CSI
ESC [
27
91
1B
5B
Parameter:
n = switch for the horizontal leading edge
n = 0 : (flush left, default value)
n = 1 :
(flush right)
Function:
Via CSI n % t, the printer control is informed to which horizontal edge the sub-
sequent print and read operations are to refer (also see section "Important notes
on document processing", subsection "Horizontal positioning" in this chapter).
– After receiving the command CSI n % t, all the characters are
i
printed which are still in the print buffer.
– If the horizontal leading edge on the right is selected (n = 1), the
left edge must be fixed logically depending on the physical docu-
ment width and the printing unit width (90 characters @ 1/ 10 inch)
(for example, via ESC l (n)) or an appropriate number of leading
spaces must be taken into consideration (for example, by means
of appropriate editing of the print data or by means of appropriate
dot positioning).
200
n %
n %
n 37 116
n 25 74
l
T5023/5023+ - Programming Guide
t Name
t ASCII character
Decimal
Hexadecimal