Tally T5023+ Programming Manual page 221

Additional commands (Printer)
– Table for recording formats
Depending on the recording formats, the user must transfer the following va-
lues via CSI ... ! r, in order to be able to process the following recording mo-
des:
Format
DIN
IBM 1
IBM 2
105 characters
ISO 7811
– Default values:
If no parameters are set, the respective MSR transactions are carried out on
the basis of the following default values:
n1 = 0 (unsuccessful writing attempts are not repeated)
n2 = 0 (unsuccessful reading attempts are not repeated)
n3 = 0 (writing of the magnetic stripe in the DIN format, reading
of the magnetic stripe in the DIN/ IBM format)
n4 =
99/180 inch vertical distance from the leading edge
n5 = 1 (bottom leading edge).
– Incorrect parameters:
If incorrect parameters are used, these are reset to their default values with
the exception of n3. The use of an incorrect n3 parameter (format) leads to
an error message of the printer.
Controlling the MSR / MICR functions
n3
0
1
2
5
6
T5023/5023+ - Programming Guide
n4
14 mm (99/180")
11 mm (78/180")
11 mm (78/180")
14 mm (99/180")
14 mm (99/180")
n5
1
1
1
1
1
211