Standard Protocols Supported - UTStarcom iSpirit 3026 Manual

allows network administrators to either aggregating 8 10/100 ports into one communication
tunnel, with a maximum of 6 trunk groups, or aggregating 2 Gigabit Ethernet ports into one
up-link communication tunnel.
2. Safety Feature
The iSpirit 3026 switch supports static configuration of ARL table and MAC address binding with
ports, thus provides MAC access filter; And the unique Hyper-safety technology can also
prevent forbidden or unallowed users to access network resources.
3. Powerful network management
The iSpirit 3026 switch uses Hyper-management technology and thus its management capability
is very powerful:
(1) can use Console and Telnet to configure with menu or CLI commands;
(2) can use a network management software based on SNMP;
(3) can configure through web with a graphics interface, which is convenient, powerful and
easy;
(4) it has been embedded with multiple network management agents, including Bridge
MIB, MIB II, Entity MIN version 2, RMON MIN and Proprietary MIB;
(5) support 4 groups of RMON network management protocols(1,2,3,9), providing various
information including statistics, history, warning and events information;
(6) easy to upgrade software: can use the in-band TFTP protocol for upgrading.
4. VLAN
The iSpirit 3026 switch supports port-based VLAN which conforms to 802.1Q standard.

1.3 Standard Protocols supported

Standard protocols supported by the iSpirit 3026 switch are shown in Table1-1.
Table1-1:
Bridge(tree protocol)
Ethernet
Fast-Ethernet
Complete full-duplex flow control
Protocols References
IEEEE802.1d
IEEE802.3
IEEE802.3u
IEEEE802.3x