UTStarcom iSpirit 3026 Manual page 177

●
the configure of TELNET instrument
1. The configure of IP DEBUG instrument
Under default, a serial port end and 5 TELNET ends of the iSpirit 3026 switch are closed.
●
under global CONFIG mode, the following command can open the IP DEBUG
configure:
debug ip
●
under global CONFIG mode, the following command can open the IP DEBUG
configure:
no debug ip
Notes:
The two commands above only can be used in serial port end rather than in TELNET end.
●
under global CONFIG mode, the following command can open the ARP DEBUG
configure:
debug ip arp
●
under global CONFIG mode, the following command can close the ARP DEBUG
configure:
no debug ip arp
●
under global CONFIG mode, the following command can open the TCP DEBUG
configure:
debug ip tcp
●
under global CONFIG mode, the following command can open the TCP DEBUG
configure:
no debug ip tcp
Notes:
The two commands above only can be used in serial port end rather than in TELNET end.
●
under global CONFIG mode, the following command can open the UDP DEBUG
configure:：
debug ip udp
●
under global CONFIG mode, the following command can close the UDP DEBUG
configure:
no debug ip udp
●
under global CONFIG mode, the following command can open the ICMP DEBUG