UTStarcom iSpirit 3026 Manual page 103

re-authentication
dot1x timeout re-authperiod <interval>
Notes:
The interval for re-authentication should not be much short, otherwise CPU resource of net
bandwidth and swithch is much consumable.
5. Configuration ports connect to Max. host computers
All ports of iSpirit 3026 switch can control Max. host computers, which may restrict user from
using many host computers connect to network illegally. The max. default is 100 to connect to
host computer, it can be set into 100 Max. The port refuses any other users to connect if it is set
into 0.
dot1x support-host <number>
Following command under global PORT RANGE mode set the port about Max. host computer
connecting to.
6. Configure intervals and re-sent times
In 802.1x protocol standard interval and re-send times of protocol Internation and protocol status
are regulated, iSpirit 3026 switch uses of standard intervals and re-send times. It is suggested
that users should not change intervals and re-send times when using.
tx-period indicates the interval that switch re-send the EAP-Request protocol; max-req indicates
the times that switch re-send the EAP-Request; quiet-period indicates that users wait for
re-authentication interval if the first authentication is failed; server-timeout indicates the interval
that switch re-send RADIUS packet to authentication server system.
Following command under globle CONFIG mode configure these intervals and re-send times:
dot1x timeout tx-period <interval>
dot1x max-req <number>
dot1x timeout quiet-period <interval>
dot1x timeout server-timeout <interval>