UTStarcom iSpirit 3026 Manual page 178

configure:
debug ip icmp
●
under global CONFIG mode, the following command can close the ICMP DEBUG
configure:
no debug ip icmp
●
under global CONFIG mode, the following command can open the SNMP DEBUG
configure:
debug ip snmp
●
under global CONFIG mode, the following command can close the SNMP DEBUG
configure:
no debug ip snmp
●
under global CONFIG mode, the following command can open the IGMP DEBUG
configure:：
debug ip igmp
●
under global CONFIG mode, the following command can close the IGMP DEBUG
configure:
no debug ip igmp
●
under global CONFIG mode, the following command can open the IGMP SNOOPING
DEBUG configure:
debug ip igmpsnooping
●
under global CONFIG mode, the following command can close the IGMP SNOOPING
DEBUG configure:
no debug ip igmpsnooping
●
under global CONFIG mode, the following command can open all the DEBUG
configures:
no debug all
●
under global CONFIG mode, it will display all open DEBUG configure information.
show ip debug-on
2. The Configure of PING Instrument
The iSpirit 3026 switch supplies with one simple and one complex PING command. A serial port
end and 5 TELNET ends can carry out PING command to test the connection between the
switch and the destination equipment.
● following command will be carried out under EXEC mode and global CONFIG mode, and
these are simple PING commands, and can be used to test the connection between the switch
and the destination equipment.
ping <ip-address>