Table of Contents
Advertisement
STP protocol should be opened before setting up the multi-sample configuration, otherwise the
setup can not be performed, and the indicated page is as follows:
Figure 18-28. Alarm Page
When configuration is performed (Figure18-29), VLAN must exist and the port should be in
VLAN, otherwise here give an alarm as follows:
Figure 18-29 Alarm Page
9. ACL Configuration of Resource Bank
(1) ACL extension MAC Configuration page
Figure18-30 is the configuration page of ACL extension MAC, by which user can set up ACL
extension MAC protocol-storage. User can choose an ACL group NO. (From 400 to 599), among
which one or more protocols can be set up (128 protocols are supported in one group at most).
The matched field contains Original MAC address (with hidden code), Purposed MAC address
(with hidden code) , Ethernet network-frame-type (such as IP, ARP and so on) and VLAN ID NO.
Hidden code can be attached to Original MAC address and purposed MAC address when user
performs configuration of protocol which can match the venue of MAC. Reversed-code is
adopted to denote the hidden code of address; if the range of MAC addresses to be matched by
protocol
is
from
00:11:22:33:44:00
to
00:11:22:33:44:FF,
the
MAC
addresses
is
00:11:22:33:44:55 with the hidden code 00:00:00:00:00:FF.
When user perform protocol of configuration, a filter-mode must be set up for each protocol
which contains four types: permission, rejection, permit all and reject all. If user selects "permit
Advertisement
Table of Contents
