Configuration Of 802.1X - UTStarcom iSpirit 3026 Manual

8.3 Configuration of 802.1x

In this Section Configuration of 802.1x is described in detail, including:
802.1x default configuration
Start and close 802.1x
Configure 802.1x Port status
Configure re-authentication system
Configuration ports connect to Max. host computers
Configuration intervals and resend times
Show 802.1x info.
1. 802.1x default configuration
802.1x default configuration of iSpirit 3026 switch is as follows
802.1x is closed
All ports are in N/A status
Re-authentication system is closed, and the interval is 3600 seconds
Max. 100 ports connect to host computers
Overtime interval to re-send EAP-Request is 30 seconds
3 times to re-send EAP-Request
Stand-by time of failed authentication is 60 seconds
Overtime interval to re-send by server is 10 seconds
Switch in global CONFIG mode provides an command to make all configurations return to
default atatus, commands as follows:
dot1x default
2. Start and close 802.1x
The first step to configure 802.1x is to start 802.1x. Under global CONFIG mode to I
nput following command to start 802.1x：dot1x
All ports status should return to N/A status when close 80 2.1 x. Under global CONFI G
mode input following command to close 80 2.1 x： no dot1x
3. Configure 802.1x ports status
802.1x must be started before configuring 802.1x. The port must be configured into Auto status if