Basic Configuration Of The System - UTStarcom iSpirit 3026 Manual

1.1 Basic configuration of the system

Users can use CLI commands in the overall configuration mode (Switch#), these commands are
used for usual management of the switch, such as changing the password, showing the
configuration information, etc....
The system is in the EXEC mode first, type the command "enable" at this time and then type the
password, the switch will enter the overall configuration mode, shown as follows:
Switch>enable
Password:
Switch#
Commands lists:
to set the IP address and netmask of VLAN1 on the switch
ip address <ip-address><subnet-mask>
Example: Switch# ip address 192.168.2.3 255.255.255.0
to set the default gateway
ip gateway <gateway-address>
Example:
Switch# ip gateway 192.168.2.1
to restart the switch
Switch# reset
to restart the switch back to factory settings
Switch# reset factory
to change the password, which needs to be typed twice. This is an interactive command
Switch# password
to save configuration to flash
Switch# save
to go back to the upper level. If the system is currently in overall configuration mode, it will go
back to EXEC mode; if in EXEC mode, the command is just like a logout.
Switch# exit
To exit from the TELNET terminal. It is applicable to any CLI mode, but not
useful in console terminal.
Switch# logout
To clear information on the screen
Switch# cls