Management Configuration - UTStarcom iSpirit 3026 Manual

3. Management Configuration

(1) Switch configuration page
Figure18-9 shows the switch configuration page by which user can perform configuration of
basic message of switch. User can perform configuration of default gateway of switch (default
route). User can read MAC address of the VLAN1 subnet of switch but can not perform
configuration. User can startup or close some basic protocol, such as STP and IGMP
SNOOPING protocol. User can re-start the switch through the page; select reset or factory
defaults from under-menu of Reset, then press APLLY or Save key. Before startup of switch,
user will be reminded to confirm selection. If user select reset, it means restart switch only; if
user select reset factory defaults, it means restart switch and make switch return to the default
status of leaving factory.
Figure 18-9 Switch Configuration Page
(2) System configuration page
Figure 18-10 shows system configuration page which provides user with system message of
switch and allows user perform configuration of some of the system message.
User can read the system description of switch, system OID, quantity of system port and startup
time of system through the page. User can perform configuration of system name, system
position, system connection and production name.