UTStarcom iSpirit 3026 Manual page 209

Table of Contents

referenced field is 0, which indicate no application adopted in the protocol, the protocol can be

configured, such as adding some protocol, deleting some protocol or amending some protocol.

When the referenced field is not 0, the protocol can not be configured.

When a protocol is set up in a group of protocol, system provide the protocol with a protocol NO.

automatically; when a protocol is deleted, others do not change and the system will arrange the

protocol in a group automatically.

(3) ACL standard IP configuration page

ACL standard IP configuration page is shown in Fig 18-31, by which protocol-storage for ACL

standard IP protocol can be configured. User may select an ACL group NO. (From 1 to 199),

among which one or more protocols can be set up (128 protocols can be supported in one

group), and only the original IP address can be matched (with hidden code).

Hidden code can be attached to Original IP address when user performs configuration of

protocol which can match the venue of IP. Reversed-code is adopted to denote the hidden code

of address; if the range of IP addresses to be matched by protocol is from 192.168.0.0 to

192.168.0.255, the IP address is 00:11:22:33:44:55 with the hidden code 00:00:00:00:00:FF.

When user perform protocol of configuration, a filter-mode must be set up for each protocol

which contains four types: permission, rejection, permit all and reject all. If user selects "permit

all" and "reject all", the original IP address and purposed IP address being set up do not work (In

fact, all the matched fields do not work) and they can be unified as: 0.0. 0.0 with hidden code:

255.255.255.255. If no field to be matched, which means empty, "Rejection" equals "reject all"

and "Permission" equals "permit all".

There is a referenced field in each group of protocol on pages, but it is read-only and can not be

configured. The field tells the user the quantity of current application of applying the protocol;