Table of Contents
Advertisement
authentication accounting depends on actual condition. To open the re-authentication function
make it much safer to use the authentication accounting, but the flux of internet might be a little
heavier.
Configuration of time intervals of re-configuration, which is available only when the function
of re-authentication is startup, with default of 3600 seconds, the value of which should be set up
during the course of authentication accounting according to actual condition, but the value
should not be too small.
Quiet Period timer should not be amended generally.
Tx-Period timer should not be amended generally.
Server timeout timer should not be amended generally.
supplicant timeout timer should not be amended generally.
Quantity of Max Request should not be amended generally.
(3) 802.1x Port configuration page
Figure 18-61 shows 802.1x port configuration page by which user can perform confirmation for
802.1x port status and maximum quantity of mainframe being supported and check the 802.1x
confirmation condition of each port. Status of 802.1xport contains four types: N/A status, Auto
status, Force-authorized status and Force-unauthorized status. When 802.1x authentication
need to be done on some port, the port should be set up into Auto status; user can access the
internet without authentication and the port should be in N/A status; the other two statuses are
seldom adopted actually. When 802.1xauthentication is performed, the maximum quantity of
mainframe connected from port default is 9 which field can be amended with 250 being
supported at most.
Advertisement
Table of Contents
