Table of Contents
Advertisement
2.4.2 Connecting module ports
As explained in Chapter 1, install a 100Base-X fiber module and a 1000Base-X fiber
using the extendible slots (can't be hot-plugged).
Notes:
Please don't remove the rubber stopple (at the ends of a fiber cable) and the rubber lid (on the
cable) before connecting, to avoid any stain or damage.
(1) Use direct-connected CAT5 or CAT5E cable to connect work stations, servers or
routers with RJ-45 ports at the front panel (as shown in Figure2-9), and use crossover
cable to connect with switches or concentrators. ? Pin description is shown in the
appendixes.
(2) Connect the other end of the cable with the RF-45 port of the connected device. The
corresponding port LEDs should turn on after the connection, otherwise it may be due
to that the connected device is power off, there is a problem with the cable, or the
interface card has a problem.
(3) If necessary you may need to reconfigure the switch and restart;
(4) Repeat step1-3 for other devices to 10/100/1000Base-T ports.
Figure2-9.servers or routers with RJ-45 ports at the front panel
Figure2-8.Connecting using the 10/100Mbps ports
module
Advertisement
Table of Contents
