Software Upgrading - UTStarcom iSpirit 3026 Manual

Uploading configuration......
Complete
Switch#
Step 4: Download the file to the switch if necessary
Switch# download configuration 192.168.0.2 backup
Do you wish to continue ?[Y/N]: y
Downloading configuration......
Complete.
Step 5: reset
Do you wish to continue?
Y: yes; N: no

1.3 Software upgrading

The iSpirit 3026 switch supports on line software upgrading. Upgrading is also done by TFTP.
1.Commands
Under overall configuration mode, you can upgrade the image file of the switch:
Switch# Download image <ip-address> <name>
ip-address: the IP address of the PC where the image file is stored;
name: the image file name.
During the downloading process, DO NOT turn off the power, otherwise you may damage the
image file, then the switch may not be able to be restarted. After downloading, you need to
restart the switch to make the new image file taking effect.
2.Software upgrading procedure
(Similar as that for configuration file downloading)
Steps:
(1) Set up the upgrading environment
Step 1: set up the network connection as shown in Figure1-4;