UTStarcom iSpirit 3026 Manual page 24

2.2.3 Install the switch on a wall
Two steps are necessary to install the switch on a wall:
(1) Install the flanges onto the switch;
(2) Install the switch onto the wall;
1.Install the flanges onto the switch
Users can install the switch on the wall either horizontally or vertically based on their own choice.
Horizontal/vertical installation: install the longer edge of the flanges onto the switch using
supplied screws, and install the shorter on to the wall, as shown in Figure2-6.
2.Install the switch onto the wall
To best support the switch and the network cable, users need to determine whether installing on
a pilaster or on a board (shown in Figure2-7), and then plug the power cord.
Figure2-6.Install the flanges onto the switch
Figure2-7.Install the switch onto the wall