The Configure Of Debug Instruments - UTStarcom iSpirit 3026 Manual

between the switch and the destination equipment, and can position the equipment which is of
error if the switch and destination equipment has not been connected.
The TRACEROUTE instrument of the iSpirit 3026 switch use UDP protocol packet to detect,
after the switch sent the UDP packet according to the TCL , and detect the state through
receiving the ICMP error packet sent back until the switch find out the ICMP packet which can't
receive the UDP destination end. And will be displayed the state information between the switch
and the destination equipment in switch, and through these information, you can position the
problems of Internet. The iSpirit 3026 supplies with a simple TRACEROUTE command and a
complex TRACEROUTE command. The simple TRACEROUTE command can only detect the
status of equipment between the switch and the destination equipment, and the complex
TRACEROUTE command has functions as follows: can set the source address UDP packet
sent, can set the overtime interval after sending UDP packet, can set the detecting times for
each middle equipment, can set the max and min TTL, can set the end number of UDP, can set
UDP packet with note route, can set take a note of equipment address between the switch and
the destination equipment, can set that there is no regular route in ICMP echoples-requesting
packet sent, and can set the connection of the route between the switch and the destination
equipment, can set that there is regular route in ICMP echoples-requesting packet sent, and can
set the connection of the route between the switch and the destination equipment, can set that
there is time note in ICMP echoples-requesting packet sent, and can take a note of the
equipment address and the time of the route between the switch and the destination equipment.
4. Introduction to TELNET Instruments In The End of Client
The iSpirit 3026 switch supplies with TELNET instrument in the end of client to configure and
manage the equipment between the TELNET in the switch and another equipment.
The iSpirit 3026 switch has a serial port end and 5 TELNET ends to carry out TELNET command
in TELNET to land in the destination equipment, and manage the destination equipment, the
iSpirit 3026 switch support a TELNET client end, when a TELNET client end is used by another
client end, another client end can't use the TELNET client end, and till the TELNET client end
drop from the client end.

17.2 the configure of debug instruments

In this chapter, we will introduce the debug instruments such as:
●
the configure of IP DEBUG instrument
●
the configure of PING instrument
●
the configure of TRACEROUTE instrument