Installation Steps - UTStarcom iSpirit 3026 Manual

2.2 Installation steps

2.2.1 Install on a desk and in a rack
When you install the switch on a desk or in a rack, please refer to the following steps:
(1) Four rubber underlays with adhesive tapes are provided with the switch. Pear off the
adhesive tape and adhere them to the lacunose positions at the bottom of the switch;
(2) Put the switch on the desk or in the rack near an DC power supply;
(3) Plug the power cord. After turned on, the system will run POST, please refer to "Power
on procedure" for more information.
2.2.2 Install in a cabinet
Warning:
To avoid hurt themselves during installation or operation, users should use effective method to
stabilize the switch. Please refer the following guidelines for safety:
(1) If there is only one device in the cabinet, install it at the bottom of cabinet;
(2) If more, install them down-to-up in the order of decreasing weight;
(3) If there are fixing equipments in the cabinet, please install them first before installing the
switch;
The supplied accessories for installation in a cabinet can be used for cabinets of 19 inches or 24
inches, the installation position is shown in Fighre2-1.
Please refer to the following steps for installing in a 19 inches or 24 inches standard cabinet:
(1) Unscrew the switch;
Fighre2-1. the installation position