UTStarcom iSpirit 3026 Manual page 55

configuration. They are mostly used under the VLAN configuration mode and the PORT RANGE
mode.
By default the iSpirit 3026 switch has VLAN 1, which has all of the ports as untagged members.
This section gives detail information for VLAN configuration:
To create and delete a VLAN;
To configure an untagged member of a VLAN;
To configure a tagged member of a VLAN;
To show VLAN information
1.To create and delete a VLAN
Users can create one or more contiguous VLANs using one command. The following command
creates VLANs under the overall configuration mode. If a vlanid is entered, it will create the
mentioned VLAN and go to the VLAN mode; if the mentioned VLAN has been created before, it
will just go to the VLAN mode without creating again; If a VLAN range like minvlanid-maxvlanid
is entered, multiple contiguous VLANs will be created, but it won't go to the VLAN mode; in case
VLANs in the range are already existent, then no creation. The command:
vlan {<vlanid>|<minvlanid-maxvlanid>}
Users can delete one or more contiguous VLANs using one command. The following command
deletes VLANs under the overall configuration mode. If a vlanid is entered, it will only delete the
mentioned VLAN; If the mentioned VLAN doesn't exist, no operation is done; If a VLAN range
like minvlanid-maxvlanid is entered, multiple contiguous VLANs will be deleted; in case VLANs
in the range don't exist, then no operation is done. Once a VLAN is deleted, all port membership
of this VLAN will also be removed. The command:
no vlan {<vlanid>|<minvlanid-maxvlanid>}
Notes:
If a VLAN is owned by a private VLAN, it can't be created or deleted.
2. To configure an untagged member of a VLAN
At the iSpirit 3026 switch, users can set untagged member ports either under the VLAN
configuration mode or under the PORT RANGE mode.
To add untagged ports under VLAN mode: