Table of Contents
Advertisement
3. ARP Classification
Static ARP: users configure the ARP in manual work, and the system cannot carry out auto
refreshing or deletion.
Dynamic ARP: the system will automatically detect the relative relationshio between IP address
and Ethernet address, and carry out real-time refreshing and maintenance.
4. ARP Command
●
Set static A R P :
Switch# arp <ip> <mac>
●
Delete static A R P:
Switch# no arp <ip>
●
Show contents in system A RP:
Switch# show arp
Sample:
Set purpose ip is 200.1.1.2, mac address is static ARP of 00:10:5f:01:02:03
Switch# arp 200.1.1.2 00:10:5f:01:02:03
Delete static ARP:
Switch# no arp 200.1.1.2
13.3 Configure Static Route
1. Summary
Users under route mode configure the static route information of switch. Static route is defined
by user, which is the route to make data packet arrive at puopose address from source address
through specific route. Static route is more important if dynamic route protocol does not create a
route to the spefic purpose address. Some static route also can be set into default route that will
send the data packet without certain route to the defaulted gateway.
Static route is configured by administrator in manual work, applied to the Internet whose
structure is much simple and there is only one way to the purpose address, and administrator
Advertisement
Table of Contents
