Snmp Configuration - UTStarcom iSpirit 3026 Manual

2. Operation Scheduling
Operation scheduling is that SNMP sends one command through set operation.
Operation of RMON table includes: Add, Delete, Modify, and Read. RMON under table operation
refers to line and field operations. EtherStatsStatus in statistics group, historyControlStatus in
history group, alarmStatus in alarm group and eventStatus in event group.
All of their valus are: valid (1), createRequest(2),UnderCreation(3) and invalid(4)
Add: Operate createRequest for line field （2）Operation, After operation line field automatically
is tranferred to underCreation （3） After configured other valid field carry out Valid for line field
（1） Operation, line field is changed into valid （1）Modify: firstly configure line field into
underCreation before modify table （3）And then modify other fields, after which carry out Valid
for line field （1） Operation， line field changes into valid （1） under the status line field changed
into valid （1 ）other line field cannot be modified. Delete: configure line field into invalid status
（4） delete one line. iSpirit 3026 switch supports RMON MIB of 1, 2, 3, 9 groups , seperately is
statistics group, history group, alarm group and event group

16.3 SNMP Configuration

SNMP configuration includes community configuration and TRAP workstation configuration of
switch. iSpirit 3026 switch default has a read-only union that is "public". The switch can be
configured with 8 unions at most. iSpirit 3026 switch default is not configured with TRAP
workstation, and the switch can be configured with 8 TRAP workstations at most.
SNMP Commands as follows:
●
snmp community mode： CONFIGURATION parameter： input with Community Name in
Internation way：the union name is Permission：read-write authority，1) read-write 2)
read-write function： configure with the union name to visit network administrator, which is
an Internation command. Users based on cues input required union name and read-write
authority.
●
snmp trap mode：CONFIGURATION parameter：input with trap name in Internation
way： trap name Target Ip Addr： purpose IP address sent by Trap Version： Edition v1, v2, and
v3 sent by Trap： Add or modify snmp trap purpose. It is an Internation command. Trap name
is only one, if existed Name is modified, the trap can be modified to send purpose subject.
Target ip addr is the purpose address to send trap ；version is sent in snmpV1, snmpV2,