UTStarcom iSpirit 3026 Manual page 66

community <community-id> {<port> <port1-port2>}[<port> <port1-port2>]...
To delete a shared port group, which will delete all ports in the group:
no community <community-id>
Notes:
If the VLAN group being configured is active, these commands won't work;
There can no separated port, but if so, it should at least have one shared port group.
5. To configure promiscuous ports in a group
To set one or more promiscuous ports
promiscuous {<port> <port1-port2>}[<port> <port1-port2>]...
To delete one or more promiscuous ports
no promiscuous {<port> <port1-port2>}[<port> <port1-port2>]...
Notes:
If the VLAN group being configured is active, these commands won't work;
There should be at least one promiscuous port
6. To enable or disable a group
The VLAN group won't be active right after VLAN and ports configuration, it needs to be
activated by specific commands.
To enable a private VLAN group:
enable
Notes:
There can be several possibilities if a VLAN group can't work:
(1) min-vlanid, max-vlanid or primary-vlanid may be 0;
(2) The VLAN range is too small, i.e., the total number VLANs in the range is less than the
sum of No. separated ports + No. shared port groups + 1, as mentioned before;
(3) No promiscuous port in the group;
(4) Neither separated port nor shared port group exists in the group;
(5) There is overlapping among promiscuous ports, shared ports and separated ports;
(6) There is overlapping for ports between this VLAN group and other groups;
(7) if a promiscuous port, or a shared port, or a separated port belongs to a normal VLAN as
untagged, it should be removed from the normal VLAN first;