Maintaining The Application And Configuration Files Through The Cli; Uploading And Downloading Application And Configuration Files Using Tftp - H3C WIRELESSACCESSCOTROLLER S7500E Installation Manual

........................................................................................
.....................Done!
6) Select 0 to return to the BootWare main menu.
7) Select 1 in the BootWare main menu to reboot the system.
If the downloaded file has the same file name with an existing file in the CF card, the system
prompts The file is exist, will you recover it? [Y/N]. If you choose Y, the existing file will be
replaced.
Make sure that sufficient space is available in the CF card. In case of insufficient space, the system
will give a prompt message.
The new application file directly replaces the existing file of the same type. In this example, the
downloaded file main.bin replaces the existing application file of the type M and becomes the only
main application file.
For details about the application file types, refer to section "Application Files" on page 5-1.
Maintaining the Application and Configuration Files Through the
CLI
After the LSQM1WCMB0 access controller module is normally started, you can upgrade, back up and
restore the application and configure files through the CLI.

Uploading and Downloading Application and Configuration Files Using TFTP

Using the LSQM1WCMB0 access controller module as the TFTP client and a file server as the TFTP
server, you can use commands on the console terminal, which can be the same file server, to upload
configuration and application files from the LSQM1WCMB0 to the file server or download the files from
the file server to the LSQM1WCMB0.
Setting up a configuration environment
1) Set up a configuration environment by referring to section "Upgrading applications through the
management Ethernet interface" on page 5-14.
Figure 5-8 Set up an environment for software maintenance through the CLI
2) Run TFTP Server on the file server and set the file path.
5-16