System Options 1; System Options 2; System Options 3 - Pyronix Matrix Series Installation Manual

!
SU PPLY FA U L T A RMED A L A R M FIRE
8
R EAD Y P.A.
D A Y T A MPE R
1 2 3 4
P .A. A B C D SET
FIR E 5 6 7 8
FUN C
9 0
Keypad Programming Procedure

7.6.1 System Options 1

BT
.
Enter To select an option use the
To save the changes press
Option Option Off = Alarm LED Off
1 AC Fail Warning enabled
2 Battery Monitoring disable
3 Link Only NVM Reset
4 No Limit Log and Event Reporting
5 Fault indication only in Tel Line fail
6 Global Tamper Alarm at 0V removed
7 50Hz AC Frequency
8 AC Derived Real Time Clock

7.6.2 System Options 2

BT
.
Enter To select an option use the
To save the changes press
Option Option Off = Alarm LED Off
1 Fault warning On Device Missing
2 Put Zone Restorals In the Log disabled
3 Engineer lockout when armed disabled
4 Do not Allow Arm When H, P, I, F, M, T
Zones Open
5 Immediate Zones Open On Exit does not
cause alarm
6 Do not Suspend Exit Timer On Open
Zone
7 Do not enable Bell / Global tamper End
of line
8 Allow Prox user codes whilst armed
enable.

7.6.3 System Options 3

BT T
.
Enter To select an option use the
To save the changes press
Option Option Off = Alarm LED Off
1 Do not hide display
2 Restore battery faults as they occur
3 Display alarm after first user code entry
(FTA mode)
*NOTE: Denmark, Norway, Finland & Sweden – Default option is On.
RINS428-5
>
and
B
. An acceptance tone will be played.
>
B
. An acceptance tone will be played.
>
B
. An acceptance tone will be played.
?
buttons. To change the option, press the
Option On = Alarm LED On
AC Fail Warning disabled
Battery Monitoring enable
Engineer code and link NVM Reset
Limit Log and Event Reporting
Alarm & Fault in Tel Line fail
Global Tamper Alarm at OV applied
60Hz AC Frequency
Quartz Derived Real Time Clock
?
and buttons. To change an option press the
Option On = Alarm LED On
Tamper Alarm On Device Missing
Put Zone Restorals In the Log enabled
Engineer lockout when armed enabled
Allow Arm When H, P, I, F, M, T Zones
Open
Immediate Zones Open On Exit cause
alarm
Suspend Exit Timer On Open Zone
Enable Bell / Global tamper end of line
Allow Prox user codes whilst armed
disable.
?
and buttons. To change an option press the
Option On = Alarm LED On
Hide display after 20 seconds of keypad
inactivity
Only restore battery faults on exit from
Engineer Mode
Display alarm as the alarm occurs
Matrix 832 / 832+ / 424
C
button.
Default
Off
On
Off
Off
Off
Off
Off
Off
C
button.
Default
On
On
Off
On
Off
On
Off
Off
C
button.
Default
Off *
Off *
Off *
Page 39