Partition Options 2; Arm Options - Pyronix Matrix Series Installation Manual

!

7.11.2 Partition Options 2

BV
Enter followed by one digit for the desired partition number [1 - 4]. To choose an option use the
> ?
and buttons. To change an option setting, press the
acceptance tone will be played.
Option Option Off = Alarm LED Off
1 Bell Time is Minutes
2 Anti-code Reset Disabled
3 Engineer Reset is Disabled
4 Reset Required after Confirmed Alarms
5 Normal Sounder Operation
6 Do not allow zone restorals after disarm

7.12 Arm Options

PC Programming Procedure
The PC window below shows arm options on the PC software. On the left hand side of this screen shot is a
partition selection box, which should be used to change between desired partitions. 1, 2, 3 and 4.
Information in 1 partition can be copied into other partitions by selecting a partition number in the partition
selection box and pressing the ">>" button.
Once all desired attributes have been chosen press <save> and proceed to the next window.
NOTE: There are 5 different exit terminator types for the arm modes A, B, C and D. Each of these arm
modes can be programmed in either Home or Away mode.
Home and Away allocation will also enable programming of partition dependency if more than one
partition is selected.
RINS428-5
C
button. To save the changes press
Option On = Alarm LED On
Bell Time is Seconds
Anti-code Reset is Enabled
Engineer Reset is Enabled
Reset Required after All Alarms
French Sounder Operation
Allow zone restorals after disarm
Matrix 832 / 832+ / 424
B
. An
Default
Off
Off
Off
Off
Off
Off
Page 63