Finding Bus Devices; Factory Default Settings Of Matrix System; Engineer Code; Global System Options - Pyronix Matrix Series Installation Manual

!

7.3 Finding Bus Devices

Every time you add or remove a device on system bus, you must rescan for bus devices, so that the panel
can recognise the new hardware. See page 99 for more details.
LH Digit – (Type)
0
1
2
3
4
5
6

7.4 Factory Default Settings of Matrix System

NOTE: This section provides default settings for Matrix 832, 832+ & 424 control panels.

7.4.1 Engineer Code

7.4.2 Global System Options

System Options 1
1 AC Fail Warning
2 Battery Monitoring
3 NVM Reset
4 Log and Event Reporting
5 Alarm in Tel Line Fail
6 Global Tamper Alarm
7 AC Frequency
8 Real Time Clock
System Options 2
1 Tamper Alarm on Device Missing
2 Put Zone Restorals in the Log
3 Engineer Lockout when Armed
4 Allow arm if H, P, I, F, M Zones Open
5 Immediate Zones Open on Exit
6 Suspend Exit Timer on Open Zone
7 Bell / Global Tamper Inputs
8 Proximity User Code Disarm
System Options 3
1 Hide Display
2 Restore Battery Faults
3 Display Alarm
RINS428-5
RH Digit – (ID)
1-4
1-4
1-4
1-4
1-4
1-4
1-4
Engineer Code
9999
Enabled
Enabled
Link Only
No Limit
Disabled
0V Removed
50Hz
Mains
Enabled
Enabled
Disabled
Enabled
Does not cause alarm
Enabled
Normally Closed
No limit
Never
As they occur
Only if panel disarmed
LCD Keypad
ICON Keypad
Proximity card reader
4-Way output expander
8-Way output expander
4-Way Zone expander / Input Analyser
8-Way Zone expander / Input Analyser
Default
Default
Default
Matrix 832 / 832+ / 424
Device Type
Notes
Notes
Notes
Notes
Page 25