Proximity Reader Programming; Changing Default Language On Lcd Keypad - Pyronix Matrix Series Installation Manual

Matrix 832 / 832+ / 424
7.9.2.6 Setting the Contrast of the LCD Display
BUWY.
Enter The following display will be shown.
F
The key reduces the contrast
G
The key increases the contrast
B
Press to accept the new contrast setting.
The LCD contrast controls the darkness of the characters shown on the LCD display.
By default the contrast is set to an optimum setting and will not automatically need to be changed. Care must
be exercised when changing the contrast so as not to loose the display completely.

7.9.3 Proximity Reader Programming

7.9.3.1 Proximity Reader Partition Allocation
BUWZ
Enter followed by 1 digit to choose proximity reader ID number from [1 - 4]. The current setting will
be displayed. Press [1 - 4] to assign partitions to the reader. To save the changes press
tone will be played.
The function will repeat from the beginning. Press
programming.
7.9.3.2 Proximity Reader Private / Public Mode
BUW[
Enter followed by the one digit for the desired proximity reader ID number [1 - 4]. To select an
>
option number use
To save the changes press
Option Option Off = Alarm LED Off
1 Proximity Reader Public Enabled

7.9.4 Changing Default Language on LCD Keypad

BUX
Enter . The following display will be shown.
Enter the keypad number [1 - 4] for the keypad you wish to change the language of. The following display will
be shown.
F G
Use the or
automatically exit.
Note: The language change will take effect only after leaving Engineer Mode.
Page 58
Adjust contrast
Use up - down keys
?
and buttons. To change an option setting press the
B
. An acceptance tone will be played.
KEYPAD
_ [ 1 to 4 ]
SELECT LANGUAGE
ENGLISH
keys to select a language. Press
MATRIX
BB
to exit proximity reader partition allocation
Option On = Alarm LED On
Proximity Reader Private Enabled
MATRIX
MATRIX
B
to accept the language. The function will
B
, an acceptance
C
button.
Default
Off
RINS428-5