Programming User Codes; User Code Partition Allocation; User Code Attributes Allocation; Temporary Code - Pyronix Matrix Series Installation Manual

Matrix 832 / 832+ / 424
SU PPLY FA U L T A RMED A L A R M FIRE
8
R EAD Y P.A.
D A Y T A MPE R
1 2 3 4
P .A. A B C D SET
FIR E 5 6 7 8
FUN C
9 0
Keypad Programming Procedure

7.8.1 Programming User Codes

The engineer should only program the user codes attributes. Codes should be allocated by the master user
only, following the procedures detailed in the user guide.

7.8.2 User Code Partition Allocation

BU
Enter followed by the two digits for the user number [01 - 32]. To select an option use the
?
buttons. To change an option press the
be played.
Option Option Off = Alarm LED Off
1 Not assigned to partition 1
2 Not assigned to partition 2
3 Not assigned to partition 3
4 Not assigned to partition 4

7.8.3 User Code Attributes Allocation

BU
Enter followed by the two digits of the user number [01 - 32]. To select an option use the
?
buttons. To change an option press the
be played.
Option Option Off = Alarm LED Off
1 Omit (Bypass) Zones Disabled
2 Normal User Code
3 Duress Code Disabled
4 Disallow Arm
5 Disallow Disarm
6 Spare
7 Spare
8 Limited User Code

7.8.4 Temporary Code

NOTE: The number of uses of the temporary code can be defined as unlimited or any number from 1
to 99.
BU T
Enter followed by the two digits of the user code number from [01 - 32]. Enter the number of uses
for the code from [00] – [99]*. To save the changes press
*[00] = Unlimited use of user code.
*[01] = Once only – after one use the code is deleted from memory.
*[02]...[99] = A number between 2-99 represents the amount of times the user code may be used – after the
programmed number of uses the code cannot be used again until an unlimited use code has been used at
least once.

7.8.5 Assigning / Clearing Proximity Card to / from User Code

The engineer should only program the user code attributes. Codes and proximity cards should be allocated by
the master user only, following the procedures from the user menu. See the user guide.
Page 52
C
button. To save the changes press
Option On = Alarm LED On
Assigned to partition 1
Assigned to partition 2
Assigned to partition 3
Assigned to partition 4
C
button. To save the changes press
Option On = Alarm LED On
Omit (Bypass) Zones Enabled
Duress Code Only
Duress Code Enabled
Allow Arm
Allow Disarm
Spare
Spare
Master User Code
B
. An acceptance tone will be heard.
>
B
. An acceptance tone will
Default
On
Off
Off
Off
>
B
. An acceptance tone will
Default
On
Off
On
On
On
Off
Off
1=On, 2-32=Off
RINS428-5
and
and