PCS - Commands
Select any desired LABELNAME made up of
a maximum of 19 alphanumeric characters.
PStop
The program runs until the Pstop command
point where it is then stopped. Select START to
continue the program.
Stop program
If the Prog.Halt command is inserted into the
sequential program the program is stopped at
this point. Select START to continue the
program.
End program
Select to end the program. The Automatic
program is stopped and the system then
switches to Manual mode.
(refer to Section 6.6
Stop program, End of
program)
A: R104GB06A.PMD
Section 6
B: R104DE06A.PMD
E: 010404 / TCS
Page 3
G: 140404 / T. Wenger